Looking for a super lightweight but badass tubeless sealant? Boom, you've just found it my friend! No Puncture Hassle Tubeless Sealant performs under the most brutal race conditions. The cutting-edge molecules fill the bigger holes and tears, whilst the advanced latex forms a strong seal instantly. Our formula also contains a unique UV detection system that highlights any punctures you haven’t seen during your ride.

Developed with the world's top downhillers and pro peloton teams, to give you the finest tyre sealant available. It's non-corrosive and easily washes off with water. Compatible with tubeless ready and full UST wheels/tyres, No Puncture Hassle Tubeless Sealant works from 15psi - 80 psi and temperatures from -20°C to +50°C. Our pouch is designed to fit your Presta valve perfectly and is ideal to add to your toolkit or ride pack for emergency top-ups on the go!

Features

For Downhill/Enduro//MTB
Seals tears and holes up to 6mm
Seals porous tyres and bead/rim gaps
Lasts up to 6+ months in temperate climates* and won't ball up
Contains cutting-edge molecules to fill large holes and tears
Includes unique UV detection system that highlights any punctures
Non-corrosive and easy to wash off with water
Ammonia free
CO2 compatible

Minimum amount per tyre:

(add up to 30ml extra for increased protection)

26" MTB & 27.5": 60-75ml (4 to 5 scoops)
Cross 700c: 60-75ml (4 to 5 scoops)
29" MTB: 105ml-140ml (7 or the whole pouch)
Downhill: 120-140ml (8 or the whole pouch)

*If using in extreme heat (+35°C) simply top up if needed.

How To

Remove all old rim strip or tape and clean rim.
Make sure the rim is clean and dry before applying tape.
Get the tape from the packet and line it up from the opposite side of the valve.
Start by unwinding a small amount of the tape and pressing it down using your thumb or finger to hold the pressure down.
Continue to hold while you pull back on the tape and stick down tight once you have a few cm on the tape will stick and holding is no longer needed.
Continue the entire way around the rim (if it has a big concave in you can pull and wiggle the tape to fill any edges)
Overlap the tape by roughly 10 – 15cm
Leave a small amount unstuck so that you can cut the remainder off
Once cut sketch and pull the tape down to create a seal
Go around the rim with your thumb to make sure there is no air pockets or messed areas.
Once you're happy with how it looks using a small pin locate the valve hole and cleanly pierce the tape ready for the valve
Grab your tubeless valve and remove the lock ring and o ring
Chose the right rubber fitment for your rim tape and insert valve into rim
Refit O-ring and Lock ring making sure you lock the valve in (don’t go too tight or could damage the rubber)
Re-fit your tyre of choice, being careful not to damage the tape (by using tyre levers etc)
Inflate tyre to create a fit (should hear some popping around the rim)
Release Air and remove valve core using the spare valve cap
Grab the sealant pouch and give it a shake
Unscrew the cap and fit on the valve in a upright position
While holding the pouch spin the wheel downward so that the pouch is now upside down
Insert the sealant by rolling the pouch down
Spin wheel back up right and remove pouch
Reinsert valve core and inflate to your pressure

Price

Collections

Sealant

Stans Tubeless Sealant 60ML

Tubeless Sealant 8oz

Tubeless Sealant

No Puncture Sealant

Stans NoTubes Sealant

No Puncture Hassle Tubeless Sealant

Original Tubeless Sealant